Page 1 of 1

Error during using Leds

Posted: Sat Apr 20, 2019 6:43 pm
by benkirat abdou
i use leds Actuator , after few second the program stopped and this message shown

[FATAL] While updating the LED grid for LED "CPFA_10.leds_0.led_2"
[FATAL] CGrid<ENTITY>::PositionToCell() : Position <2.86779,-5.00072,0.085> out of bounds X -> -5:5 Y -> -5:5 Z -> 0:1

why this error ??

Re: Error during using Leds

Posted: Sat Apr 20, 2019 6:54 pm
by pincy
Because your robot is going out of the arena. Add thicker walls and make sure the robot speed is not too high. 20 cm/s is a good limit for speed.

Re: Error during using Leds

Posted: Sat Apr 20, 2019 6:59 pm
by benkirat abdou
but, when i remove leds no problem !!!!

Re: Error during using Leds

Posted: Sat Apr 20, 2019 7:12 pm
by pincy
LEDs are around the body of the robot, so they're the first thing to go out of the arena.

Re: Error during using Leds

Posted: Sat Apr 20, 2019 7:33 pm
by benkirat abdou
thanks, you are helpful